As usual, confusion motivates me to blog some more. In this case, I have blogged this because I was confused, and I am pretty sure that I have it straight now. Comments may prove me wrong.
When designing, planning, testing, and implementing Network Load Balancing (NLB) Clustering, a choice has to be made regarding unicast vs. multicast. There are a few differences, but the main difference is in the way MAC addresses are implemented.
Unicast – Each NLB cluster node replaces its real (hard coded) MAC address with a new one (generated by the NLB software) and each node in the NLB cluster uses the same (virtual) MAC. Because of this virtual MAC being used by multiple computers, a switch is not able to learn the port for the virtual NLB cluster MAC and is forced to send the packets destined for the NLB MAC to all ports of a switch to make sure packets get to the right destination.
So, basically, the way NLB traffic is handled is kind of like this:
1. An inbound packet for IP address w.x.y.z (NLB Virtual IP) arrives
2. The ARP request is generated and is sent across all ports of the switch since there is no mapping at this point
3. All of the NLB cluster nodes respond with the same MAC
4. The switch sends the traffic to all ports because it is not able to tell which is the proper port and this leads to switch flooding
If an NLB cluster node is using unicast, NLB isn’t able to tell each node apart as they all have the same MAC. Since each NLB cluster node has the same MAC, communication between NLB cluster nodes is not possible unless each NLB cluster node has an additional NIC with a unique MAC.
Multicast – NLB adds a layer 2 MAC address to the NIC of each node. Each NLB cluster node basically has two MAC addresses, its real one and its NLB generated address. With multicast, you can create static entries in the switch so that it sends the packets only to members of the NLB cluster. Mapping the address to the ports being used by the NLB cluster stops all ports from being flooded. Only the mapped ports will receive the the packets for the NLB cluster instead of all ports in the switch. If you don’t create the static entries, it will cause switch flooding just like in unicast.
- Hook all NLB devices to a hub and then connect it to a port on the switch. Since all NLB nodes with the same MAC come through the same port, there is no switch port flooding.
- Configure a VLAN for all NLB cluster nodes to contain all NLB cluster traffic to just the VLAN and not run it over the entire switch.
- Use multicast and configure static mapping for the NLB cluster nodes in the switch so it only floods the mapped ports instead of the entire switch.
- Use port mirroring so that all ports involved in the NLB cluster mirror each other.